Bath Fixer Barnet provide industry-leading solutions for acrylic bathtub restoration, restoring acrylic shower trays, ceramic sink repair, high-quality enamel restoration, and hard surface repairs.
Acrylic tubs are relatively delicate and are susceptible to damage from dropped tiles while tiling. Occasionally a glass partition to shift and cause a visible indentation. The lip on the edge of the bath can crack if it bears too much weight or is leveraged when removing the panel. Many times, an acrylic bath can be damaged in storage or transit.
Whatever the situation is, we can provide a professional solution.
Call us, or submit a service request, or send us pictures via WhatsApp or SMS, and we’ll let you know the best solution.
Once on-site, our team shield the ground surface, commode, basin, warming appliances, and key sections of the bathroom.
We thoroughly clean the bath using industry-approved solutions and eliminate old, degraded sealant.
We restore and fix imperfections, including small fractures and surface chips, surface marks, mineral deposits, and erosion caused by minerals in water. If the base of your bath has cracks or holes, we reinforce and fix it completely.
We mask off the tiles, walls, bathroom fixtures, drain opening, and bath overflow using protective masking tape to ensure no overspray affects them.
We work with a high-strength degreasing solution to eliminate any grease, accumulated grime, impurities and stains.
Then we spray on the second bonding agent with a hot air gun. Unlike other bath re enamelling companies we use two bonding agents so the enamel surface we spray on has a very strong hold to the original surface.
Then we spray on the reinforcing primer for maximum surface adhesion.In contrast to many resurfacing services, our process includes a double-bonding system, so the enamel surface we spray on firmly adheres for long-lasting results.
We employ an specialized infrared drying technology to cure the new enamel and remove the masking.
After that, we apply expert refinements, ensuring a flawless, mirror-like finish to deliver a pristine, professional-grade outcome.
As a finishing step, we seal with a high-quality sealing layer so the surface is watertight and secure.
Stone work surfaces can be chipped along the edges, because this area lacks structural support.
The material is not supported on the open edge, and a hard object like a pot may cause a small section to break away.
- Stains and Discolouration Although they are stain-resistant, some substances and spills might result in deep-set stains on these surfaces.
- Chips, Scratches, and Dents Unexpected nicks, forceful blows, or daily use can result in light surface marks or indentations on the worktop.
- Edge Damage The most exposed areas, under sudden pressure, can chip, affecting its flawless appearance.
