Bath Fixer Hackney are specialists in acrylic bathtub restoration, fixing cracks and damage in shower trays, chip and crack repair for sinks, bathtub reglazing, and damage repair for solid surfaces.
Acrylic bath surfaces are not as hard as other materials and may incur damage from falling tiles during tiling. At times a shower guard to dislodge and create a surface gouge. The bath’s edge can be split if too much weight is put on it or is impacted when adjusting surrounding tiles. Frequently, an acrylic bath can be damaged in storage or transit.
No matter the damage, we can provide a professional solution.
Reach out to us, or send us a quick message, or message us with a few photos, and we’ll offer professional recommendations.
Upon arrival, we shield the bathroom floor, toilet, washbasin, radiators, and key sections of the bathroom.
Our team deep cleans the bathtub with high-quality bath-safe products and eliminate old, degraded sealant.
We restore and fix imperfections, including small fractures and surface chips, cosmetic imperfections, hard water stains, and worn away enamel from hard water. If there are holes or damage at the bottom of the bath, we restore it professionally.
We mask off the bathroom tiles, walls, faucets, bath drain, and overflow with masking to avoid any coating residue.
We work with a special cleaning solvent to dissolve and lift grimy deposits, surface contaminants, any remaining debris.
Then we spray on the second bonding agent with a hot air gun. Unlike other bath re enamelling companies we use two bonding agents so the enamel surface we spray on has a very strong hold to the original surface.
We proceed by spraying the reinforcing primer through heat-assisted bonding.In contrast to many resurfacing services, we apply an extra adhesion layer, allowing the reglazed bath forms an ultra-durable bond.
We apply an infrared low-bake system to bond the refinished surface and unveil the fully restored bath.
Following this, we apply expert refinements, buffing, refining, and perfecting the surface to make sure it’s perfect.
We then carefully apply a high-quality sealing layer so the surface is watertight and secure.
Stone work surfaces are prone to chipping at the corners, due to their exposed design.
The overhanging edges are particularly susceptible, and an impact from a heavy item could result in a noticeable chip.
- Stains and Discolouration Despite their resistance, certain chemicals or foods have the potential to leave stubborn discoloration on these surfaces.
- Scratches and Dents Unintentional knife marks, strong collisions, or daily use can result in light surface marks or indentations on the worktop.
- Chipping The most exposed areas, under sudden pressure, can chip, compromising the worktop’s seamless look.
